|
|
Post by RobertsClif on Oct 30, 2021 19:09:07 GMT
I have 20 large and 4 small Hard drive disk Platters.
I have been wanting to create a wind chime, but guess what I have no ideal where to start. Was an looking for some help using a 3D Printer to create the main structure for the wind chime then I could hang some of the HDD disk platters beneath.
Disk Platters Image below.  .
These platters have a mirror surface and have a pure tone when they strike each other. Any suggestions would be appreciated.
|
|
|
|
Post by Xayoz on Nov 1, 2021 11:40:04 GMT
not sure you would need much...a flat plate with a hoop on top to hang from and holes around the edge, maybe some holes in the middle. hang everything through the holes with fishing line
|
|
|
|
Post by RobertsClif on Nov 1, 2021 19:25:26 GMT
I was going to use fishing line, platters are 3.75" across.
This would mean that each plate should hang a little less apart this will ensure that when the wind blows the plates will contact each other.
Just do not have any knowledge on wind chime design, with size shape ect, ect...
I will think about it and figure something out for sure!!!
|
|
.
