Post by RobertsClif on Jan 23, 2022 20:20:10 GMT
I configured Marlin 1.1.9BF several time today for Bl-Touch with no success.
Could not get the 3D-Touch to connect with D11 Pins so I pulled off the white connector plastic cap.
This exposed all 12 pin headers however 3 pins were cut short seen in image below.
This could also explain why I could never get it to work before, the pins were not long enough.
My 3DTouch has a different wiring needing me to swap my red an Brown wires to correspond with the connections.
When I flashed My Marlin 1.1.9BF-BL an homed it would travel XY then start Z the pin would drop and return to its home position.
Its as if it is already touching the build plates I inverted Z_Min_endstop with no change.
Will thank about this for a while to see what I did wrong.
I will completely check all my firmware configurations.
Any help would be appreciated
An Thanks in advanc
Could not get the 3D-Touch to connect with D11 Pins so I pulled off the white connector plastic cap.
This exposed all 12 pin headers however 3 pins were cut short seen in image below.
This could also explain why I could never get it to work before, the pins were not long enough.
My 3DTouch has a different wiring needing me to swap my red an Brown wires to correspond with the connections.
When I flashed My Marlin 1.1.9BF-BL an homed it would travel XY then start Z the pin would drop and return to its home position.
Its as if it is already touching the build plates I inverted Z_Min_endstop with no change.
Will thank about this for a while to see what I did wrong.
I will completely check all my firmware configurations.
Any help would be appreciated
An Thanks in advanc