|
|
Post by RobertsClif on Feb 24, 2022 20:29:05 GMT
My most hated repair is tightening a single set screw holding Throat for my Cheap Hot-End.
The set screw in question is in my opinion to small for the job in question. I need to purchase a tap n die for a larger set screw including the set screws and enlarge this set screw.
|
|
|
|
Post by Xayoz on Feb 25, 2022 11:21:30 GMT
sticking with the same hotend, or going to experiment with something like the new E3D Revo?
|
|
|
|
Post by RobertsClif on Feb 25, 2022 13:05:41 GMT
I Like this Hot-End.
It was in my opinion designed with an undersized set screw.
If you try to get it tight you can strip the set screw allen key, If you under tighten the set screw it will wobble.
I need to purchase a larger Set screw with the proper size drill bit an a tap and die for the new set screw.
Then I will be able to apply correct set screw tension.
Soon may decide to purchase a new 32bit controller with the capability of powering three hot-ends yhen will see what space is available.
|
|
