|
Post by RobertsClif on Mar 10, 2022 1:54:26 GMT
Hello Forum found some problems with Marlin 2.0.9.3 and reverted to Marlin 2.0.9.2. Already see a better quality print, I stopped for a quick test of Marlin 2.0.8.2 and found even problem there even Stepper motors were sounding funny.
Another Problem: I have been using the same configuration on all marlins for my testing and the Babystep Z has not functions correctly I can now see all sub-menus for Babystep + Probe_Offset_Wizard + my Combined M851 Z and Babystepping Total
With every thing working Will be testing Marlin 2.0.9.2 lot more.
|
|
|
Post by RobertsClif on Mar 10, 2022 11:38:16 GMT
After further test of Marlin 2.9.2 this is going to be my next testing base version.
I melted a nozzle size hole 25mm south of center of bed an decided to center nozzle to bed using firmware change.
The original code only centers the Proximity sensor adding 25mm to the Y Axis will offset nozzle too true center of bed.
#if ENABLED(Z_SAFE_HOMING) #define Z_SAFE_HOMING_X_POINT X_CENTER // X point for Z homing #define Z_SAFE_HOMING_Y_POINT Y_CENTER + 25 // Y point for Z homing #endif
|
|
|
Post by RobertsClif on Mar 12, 2022 17:23:36 GMT
As of few minutes ago all three of my 3D Printers have been flashed with my next step firmware for Hictop working is Marlin 2.0.9.2 sense may last choice Marlin 2.0.6.3. I was testing Marlin 2.0.9.3 though it had a few more failures than was willing to live with. Marlin 2.0.9.2 has finally printed on all of my Printer a working Nasa Wrench. And finally I have PROBE_OFFSET_WIZARD working correctly with BABYSTEP_DISPLAY_TOTAL I can finally see my baby step offset displayed.
Viewing this offset allows me to add or subtract and to store offset this new offest. This means that once offset is stored I do not need to baby step every print to get that perfect 1st layer height.
|
|
|
Post by RobertsClif on Mar 13, 2022 22:47:20 GMT
And believe if or not Decided to change the XY axis steps per unit from 80 to 79.7, I know the differences is not much but what the heck. An Left the Z-axis alone as it was so near perfect...
|
|
|
Post by Xayoz on Mar 14, 2022 10:50:09 GMT
why not, if you're already in there
|
|