Post by Tech Gorilla on Aug 5, 2022 2:39:45 GMT
Well, I leveled up the bed real quick, did a 12 point mesh level not so quick and stored the settings. I also took note that I have an acceleration setting in my Marlin, so I dropped all speeds to 1500 max (from 3000) and saved settings again.
I started a calibration cube and adjusted new X-Height (and stored.) It printed flawlessly. It even measures respectable. The best news - IT'S SILENT!
It's absolutely quiet. I'm sitting with my mouth hanging open. The part cooling fan is the loudest thing in the room. It's like a cloud, my friends. I'd almost say that it's a step up from the already fabulous Ender 3 Original.
After the cube was done, I set up a Benchy and using Curas Acceleration control settings, I backed all speeds down to 1200. It's printing now. I'll update with a photo when it's done.