|
Post by RobertsClif on Apr 20, 2024 0:30:50 GMT
With My Hictop I started with the basic parts cooling fan Duct. this was very basic and would not allow me to ever 3D Print a simple Bridge.
I keep looking at all the different designs though some did not allow even even the simplest of views of the printing part. This made in near impossible to see.
So I developed a right Hand cooling Duct that worked for me with an extra vent to cool the throat nozzle fins I installed.
This could be modified for a left handed person below is what I came up with.
Not a bad version though too still too weak, just like the original Duct.
In order to get the Proper cooling I am using extruder 2 as the parts Duct Fan speed controller.
|
|
|
Post by RobertsClif on Apr 20, 2024 0:54:42 GMT
This means that in order to print multi-colored models I need to swap filament during prints .
As in this Space X launch pad coaster.
The above print turned out much better than I expected
Though there are many models where you can simply print each part in a single color filament and assemble into a Color Model . as in Mario below.
|
|