|
Post by RobertsClif on Oct 11, 2020 0:13:38 GMT
|
|
|
Post by RobertsClif on Dec 15, 2020 16:06:27 GMT
Sometime I need to get back on this project, the parts have arrived and would like to re-wire the steppers to run in series. This will free up my extruder Stepper drivers which will allow me to add single or dual extruder's with 3D Printing. This will give me a print area of 490mm x 720mm x 200mm using software endstops.
|
|
|
MPCNC
Aug 15, 2022 14:18:40 GMT
Post by RobertsClif on Aug 15, 2022 14:18:40 GMT
As of today my MPCNC has been dissembled into a box of the basic components. I kept the pipe guide assemblies, XYZ Burley, cable chain holders and electronics most if the other parts and quickly printed models made it into a circular file.
I did keep my Dewalt an other essential pieces.
|
|
|
Post by RobertsClif on Nov 28, 2023 13:53:39 GMT
Posting this video of a ABS print from inside my homemade environmental 3D Printer temperature chamber , of a Burly part using Octolapse with a Octoprint controller. This is an ABS model printed with a 3D Printer was told could never be able to print using ABS.
|
|