|
|
Post by RobertsClif on Jan 17, 2021 16:10:32 GMT
This is the quickest an best way to compile Marlin firmware in under a minute then upload in to the controller.
|
|
|
|
Post by RobertsClif on Jun 13, 2021 15:42:45 GMT
Today I am preparing for new controllers BIGTREETECH SKR V1.4/V1.3 using my Ramps configured marlin firmware for the new controller.
I have a few questions regarding use of a different pin for my Filament run-out sensor the compiling went smoothly using Visual Studio Code>PlatformIO>Marlin Auto Build. This new pin is P1_28 and currently using Pin 19 with my Ramps compatible controller which would be Z-Max pin P1_24. Need to look at a Bigtreetech pins map to get a better ideal of the pins and connectors layout.
|
|
