|
Post by phil1337 on Feb 7, 2021 12:50:24 GMT
Hello Everyone,
I upgraded my Ender 3 Pro with the 32 bit board but I cant connect it to my PC. The device manager doesn't show anything. Otherwise the board is working fine.
I tried the following:
-various different cables-Laptop and 2 Tower PCs (all Win10)
-installing the CH340 Drivers (i tryed the version from th3d and the one on the stock sd card)
-new firmware (Marlin v2.0.x bugfix)
-sacrificing a goat to the gods
Since the only forum entries resembling my issue related to octoprint i thought the board was broken and ordered a new one but it has the same issue... (i have not installed the new one in the printer but the power from the usb cable should be enough to show in the device manager or not? It is with the old board anyways)
Since the same issue occurs with multiple PCs and boards it has to be something stupid i am not aware of... Or does the new board require power from the main power supply to establish connection and my first board is actually broken??
Thank you in advance.
Regards,
Phillip
|
|
|
Post by Xayoz on Feb 7, 2021 14:46:15 GMT
never tried connecting mine to PC, but you could try updating drivers from the bottom of this link...I don't know which would be correct, but I'd just install both... support.th3dstudio.com/hc/?top-category=downloadsafter that, check device manager for any drivers that are having issues.
|
|