|
|
Post by RobertsClif on Mar 15, 2021 12:12:59 GMT
Found this extruder calibration link and though it was so well written that I would re-post link here.
Hope this will be of use to some!
|
|
|
|
Post by martin on May 29, 2021 1:51:18 GMT
I see this method everywhere, but I don't like it much. The reason is that there's a lot of variables in a single wall - in particular the repeatability of the axis. I've a full writeup on my preferred calibration techniques here (including why my reasoning about the problems with the single wall approach). www.cartesiancreations.com.au/why-you-shouldnt-calibrate-your-3d-printer/My preferred method is a "bulk" extrusion check, which minimises the issues with axis repeatability and doesn't require any tools. www.thingiverse.com/thing:1622868 |
|
